easy steps to led strip installation

by:DGT Lighting     2020-03-03
Businesses and families should take advantage of the benefits and effectiveness that LED lighting solutions offer.
The installation of the Led can be used for temporary purposes, such as the case of holiday lighting decoration, as a permanent lighting solution for building signs, displays, task lighting, etc.
The LED light strip is the answer to the lighting under the cabinet, especially in the kitchen where there must be working space.
A wide variety of color options also make it possible for a variety of decorative items.
In general, LED light strips are also widely referred to as ribbons or belts.
The LED is attached to the length of these strips.
It can be spliced into any length you need at certain cutting points.
Backing is widely used for straight edges and curves.
In addition, its thinness makes it perfectly hidden in display cabinets, embedded and subtle lighting settings.
Standard LED tape with backlight comes with double sided tape for lighting.
These adhesive parts can be located on the back of each lamp strip in order to facilitate installation and avoid other confusing adhesive modes.
Here is a quick step-by-step guide on how much trouble it is to install your own LED light strip.
Positioning first determines where you plan to install the led light strip to produce the effect you want.
As mentioned earlier, the LED tape installation is simple and quick, but it would be best if you had a set location instead of constantly moving your installation as this could lead to a mess
When in doubt, simply place the strap in place without first sticking it in place.
Then test how the light drops and enhances the area by repositioning the strip several times.
Many people are lazy and would rather work by simply \"staring\" at the space or part of the strip to be installed.
In order to avoid having to redo the whole process of pasting the tape because of the wrong position or bending of the tape.
It would be wiser to make and pencil in some measurements.
This allows you to determine where to properly install your straps and how many straps you need.
Once you know the exact length of the surface, you can now use the measurements on the tape and do the corresponding cutting.
As a perfectionist, there is no harm in double checking.
To ensure that the stripes are cut correctly, be sure to check the measurement results carefully.
According to the rule of thumb, you should only cut on the specific cutting marks found on the tape.
The surface you are working on needs to be clean and dry.
Because there is dirt and dirt or a damp surface that affects the adhesion of the tape, this pressure cannot be large enough.
Once you are ready to install, just peel off the backing.
Press the LED ribbon firmly in the specified position.
Connect the LED to the power supply, but not the least.
This can be in the form of a standard wire or LED driver.
Turn on the lights and you can install them!
Custom message
Chat Online
Chat Online
Chat Online inputting...